Hexa Command Hub Flashing Error

When uploading the “RobotMain.ino” file onto the Hexa Command Hub by using the provided cable, even when the code upload is a success, the “Team Number” and “Wi-Fi Channel” does not appear instead the message “NOT PAIRED ____ Hold 3s button to start pairing”. Due to the above-mentioned error, we are unable to proceed with our work. Please tell a solution to this problem soon. Could you also clarify the process more.

                  - Ved Pawar: Team #240

hi, we had the same issue hold the button on the hub for three seconds to put it into pairing mode. then go to the controller and start pairing from there.

important: that button on the hub gets stuck so wiggle it arround while trying to hold it down and it should work. keep holding the button down and moving it arround until it goes into pairing mode

1 Like

Thanks, but which button is to be held, the “BOOT” button or the “RESET” button?

Also, the command hub already displays the pairing sequence, so should we directly pair?

-Ved Pawar: Team #240

None of the 2. There is a third button that is yellow-ish coloured. You need to press that. The reset and boot button are used by NRL to put the board in download mode so as to upload the firmware, so it is best if you leave those. However, it is ok if you accidentally press one of them. Nothing happens when you press boot but when you press reset, the board restarts.Good luck with your code test!

From team 106.

Thanks @SuchirA_106. We actually recieved the kit quite later due to which we are yet to start making the kit but your reply helps a lot.

Thanks a lot once again.

-Ved Pawar: Team #240

1 Like

Happy to help! If you need any other help, feel free to reach out.

1 Like