we have completed the gripper however the problem is that when we press the button for the claw of the gripper to open to pick up the element it fully goes outwards and when we again press another button to close it , the claw closes half way and we are unable to pick up the scoring element. We tried different caliberations however still facing the same problem again and again . please give a solution for this. also when we turn the robot on the claws automatically open fully outwards
update now when we turn the robot on the claw automatically goes outwards and does not close inwards
Bro, first, try replacing the gripper’s servo motor, as it might be faulty. If the servo is forcefully rotated by hand, its internal gears can get damaged, which may cause problems with opening and closing the claw.
If the issue persists even after replacing the servo, check your code and try adjusting the degree values set for opening and closing the gripper. You may need to use a trial-and-error approach to find the correct angles for your claw.
Also, since the claw opens fully as soon as you turn on the robot, check the servo’s initial position in your code and make sure it is set correctly during initialization.
Try these steps, bro. Hopefully, this will help you identify and fix the issue!
Thanks me later!
Abhishek Singe
Team RoboXtream
And also change your username bro NRL team will not give reply to this username
The username formate must be (Yourname_Teamid)
id suggest using the servo caliberation on your controller. it is much easier to check with. use it to figure out if you servo is faulty. if it is fine you can also check the correct servo angle values there via trial and error
first close the gripper fully, till where it closes, and then open the gripper, make sure to not rotate the servo mo9tor, and then close the two claws fully with your hands and keep in mind that the servo is detached from the claws, then after fully closing them, connect the servo, and then try to close and open the gripper mechanism through the remote, it should work, worked for our team.
When you turn the robot on the claws open fully outwards because it is set to its default position you can keep it as you want. And try checking the servo motors if they are working properly and check the value in the code and the manual calibrations from the controller itself.